■
3-6
c) Attaching probe to arm
1) Take out the probe holder key (3), which you can find when turning the top
cover (2) of the probe holder (1) of the arm away.
2) Remove the cable (4) from the probe while pressing the lock release button
(7) of the probe.
3) Insert the probe into the probe holder (1) of the arm from below.
4) Insert the probe holder key (3) into the ditch (5) of the probe.
5) Close the top cover (2) and fix the probe firmly.
6) Connect the probe cable (4) to the probe. Insert it in until it clicks.
7) Attach the clamp (6), which is provided with the main unit of the arm, to the
hole at the arm joint and fix it through a probe cable, as necessary.
(3)
(2)
(1)
(4)
3-03
(5)
(6)
(Fig. 1)
(Fig. 3)
3-04
(7)
(Fig. 2)
Connected with a probe cable
3-05
To Next Page
Loading...
