Tonghui TH2816B - Page 3

3
4.3.1.2 Test Frequency ........................................................................................................23
4.3.1.3 Oscillator Level.......................................................................................................24
4.3.1.4 Measurement Range................................................................................................25
4.3.1.5 Measurement Speed................................................................................................26
4.3.1.6 Short Correction......................................................................................................26
4.3.1.7 Open Correction......................................................................................................27
4.3.1.8 File Management.....................................................................................................27
4.3.1.9 Useful Tools ............................................................................................................29
4.3.2 Bin Number Display Page.......................................................................................30
4.3.2.1 Comparator Function ON/OFF ...............................................................................31
4.3.2.2 Auxiliary Bin ON/OFF ...........................................................................................31
4.3.2.3 File Management.....................................................................................................32
4.3.2.4 Useful Tools ............................................................................................................32
4.3.3 Meas Setup Page.....................................................................................................33
4.3.3.1 Trigger Mode...........................................................................................................35
4.3.3.2 Output Signal impedance........................................................................................36
4.3.3.3 Delay Time (DELAY ) ............................................................................................36
4.3.3.4 Averaging Rate (AVG)............................................................................................36
4.3.3.5 Signal Level Monitor ON/OFF...............................................................................36
4.3.3.6 Deviation Measurement Function...........................................................................37
4.3.3.7 File Management.....................................................................................................38
4.3.3.8 Useful Tools ............................................................................................................38
4.3.4 Limit Table..............................................................................................................38
4.3.4.1 Nominal Value for tolerance mode..........................................................................39
4.3.4.2 Swap Parameter Function........................................................................................40
4.3.4.3 Comparator Function's Limit Mode........................................................................40
4.3.4.4 Comparator Function ON/OFF ...............................................................................40
4.3.4.5 Auxiliary bin ON/OFF............................................................................................40
4.3.4.6 Low/High Limit Value ............................................................................................40
4.3.4.7 File Management (File)...........................................................................................41
4.3.4.8 Useful Tools ............................................................................................................41
4.3.5 System Configuration Page.....................................................................................41
4.3.5.1 LCD Contrast Function...........................................................................................42
4.3.5.2 Information Beeper Function ON/OFF...................................................................43
4.3.5.3 Comparator Alarm Function ON/OFF ....................................................................43
4.3.5.4 Password Function ..................................................................................................43
4.3.5.5 Bus Mode Function.................................................................................................44
4.3.5.6 GPIB address...........................................................................................................44
4.3.5.7 AutoFetch mode ON/OFF.......................................................................................44
Chapter 5 Remote Control ..............................................................................................................45
5.1 RS232C Interface Introduction ...................................................................................45
5.1.1 RS232C Connection................................................................................................45
5.1.2 Communication with a Computer ...........................................................................46
5.1.3 Communication with a DC Bias Current Source ....................................................49
5.2 GPIB Interface Introduction........................................................................................50
5.2.1 GPIB Connection ....................................................................................................50
5.2.2 GPIB Interface Capabilities Functions....................................................................53
5.2.3 GPIB Addressing.....................................................................................................53
5.2.4 GPIB Bus Function .................................................................................................53
5.3 Data Format.................................................................................................................53
5.3.1 Format 1..................................................................................................................54
5.3.2 Format 2..................................................................................................................55
Chapter 6 Command Reference......................................................................................................56
6.1 Notation Conventions and Definitions........................................................................56
6.2 Command Structure.....................................................................................................56
6.3 Command Abbreviations.............................................................................................58
6.4 Suffix Units and suffix Multipliers .............................................................................58