69
If the latest measurement data has been sent out, the new measurement is not begun
or the new measurement is not over, then the FETC? command will be valid after the
new measurement is over.
FETC? Command can only be used on MeasDisplay, BinNo. Disp, Bin Count and
List Sweep page. The query response returned will be “9.9E37,9.9E37” on other
pages.
On List Sweep page, if the list sweep mode is “STEP” mode, the measurement
results for one sweep point will be returned. If the list sweep mode is “SEQ”, the
measurement results for all sweep points will be returned. If one list sweep parameter
point is not set, the query response will be “9.9E37,9.9E37”.
:Source MONitor?
The :Source MONitor? query sets the latest measured voltage and current monitor
data into the TH2816B's output buffer.
Query Syntax
FETCh:SMONitor?
Query Response
Returned format is :
<NR3,NR3><NL^END>.
The latest measured monitor data will always be set in TH2816B’s output buffer, even
if the monitor data has been read out before.
The command can only be used on the four display pages under DISPLAY menu,
and the level monitor must be set to ON, otherwise returned data is “9.9E37,9.9E37”.
6.5.8 ABORt Subsystem
TH2816B will halt the current measurement, once ABORt command is received.
Command Syntax
ABORt
Example
WrtCmd(“ABOR”)
6.5.9 CORRection Subsystem
The CORRection subsystem command group sets the correction function, including
the the OPEN/SHORT/LOAD correction settings. Figure 6-7 shows the command
tree of the CORRection subsystem command group.
CORRection :OPEN :STATe ON (1)
OFF (0)
:SHORt :STATe ON (1)
OFF (0)
Figure 6-7. CORRection Subsystem Command Tree
:OPEN
The :OPEN command executes 16 presetted OPEN correction data measurement
points.
Command Syntax
CORRection:OPEN
To Next Page
Loading...
