70
Example
WrtCmd(“CORR:OPEN”)
When a command needs a long time to execute for example the OPEN/SHORT
command. The controller should not send the next command before the former
command is finished. On GPIB bus, RFD can be used to dominate the BUS before
the command is finished. While on RS232C bus, the first character of the command
will be ignored by the instrument, if the controller sends the command before the
former command is finished.
:OPEN:STATe
The :OPEN:STATe command sets the OPEN correction function to ON or OFF.
The :OPEN:STATe? query returns the current ON/OFF condition of the OPEN
correction.
Command Syntax
ON
OFF
CORRection:OPEN:STATe 1
0
Where,
1 (decimal 49) When the function is ON
0 (decimal 48) When the function is OFF
Example
WrtCmd(“CORR:OPEN:STAT ON”)
Query Syntax
CORRection:OPEN:STATe?
Query Response
Returned format is :
<NR1><NL^END>
:SHORt
The :SHORt command executes 16 presetted SHORT correction data measurement
points.
Command Syntax
CORRection:SHORt
Example
WrtCmd(“CORR:SHOR”)
:SHORt: STATe
The :SHORt:STATe command sets the SHORT correction function to ON or OFF.
The :SHORt:STATe? query responds the current ON/OFF condition of the SHORT
correction.
Command Syntax
ON
CORRection:SHORt:STATe OFF
1
0
To Next Page
Loading...
