Topcon DL-501 - 15.2 Deleting a JOB

73
15. SELECTING/DELETING A JOB
It is possible to clear the data within a designated JOB. After the data has been cleared, the JOB name
returns to the name allocated when the DL was shipped.

• A JOB (containing a route) that has not been output to an external device cannot be deleted.
PROCEDURE
1. Select “Management” in <Menu>.
2. Select “JOB" in <Management menu>.
<JOB menu> is displayed.
3. Select “JOB deletion”.
4. Align the cursor with the desired JOB and
press {}.
5. Press [YES]. The selected JOB is deleted and
the JOB list is restored.
.
15.2 Deleting a JOB
Job menu
1.JOB selection
2.JOB deletion
3.Comms output
4.JOB backup
5.JOB restore
JOB1 20
JOB2 20
JOB3 15
JOB4 10
JOB5 54
LASTTOP
...P
Job deletion
JOB1
deletion
Confirm ?
YESNO
DL-501_E.book 73 ページ ２０１５年９月１７日 木曜日 午後１時２１分