18. OUTPUTTING DATA
92
• Do not disconnect the USB memory or turn
off the DL while files are being copied/
transferred.
11. Press {ESC} to return when "Completion" is
displayed.
• Start cond. input in steps 4 to 5 is optional when restarting measurement of a partially-completed
route.
• Conditions such as character input restrictions, input range, and selectable options for the above
data items are as follows.
• Output format: CSV_1 (output of measurement results by instrument station for all measurements)/
CSV_2 (measurement results by instrument station split into foresight and backsight before output.
Elevation and dH values output in foresight data)/SDR2X
• Com.locat.: Com (output to connected device via RS232C or Bluetooth wireless technology
depending on "Mode" setting)/SD/USB
• USB memory devices up to 4GB supported.
PROCEDURE Outputting route data to host computer
1. Connect DL and host computer by attaching
the communication cable to the Multi Port.
2. Select “Route” in <Management menu>.
3. Select “Comms output”.
4. Select format from "CSV 1", "CSV 2" or
"SDR2X".
5. Check that "Com. locat." is set to "Com".
6. Press [OK].
18.2 Outputting Route Data
Route menu
1.Route setting
2.Route deletion
3.Comms output
4.View
5.IS deletion
DL-501_E.book 92 ページ ２０１５年９月１７日 木曜日 午後１時２１分
To Next Page
Loading...
