29
9. CONNECTING TO EXTERNAL DEVICES
The DL can be connected to a data collector to allow remote operation. Read this manual in
conjunction with the operator’s manual for the relevant external device and software thereof.
The Bluetooth module incorporated in the DL can be used for communication with Bluetooth devices
such as data collectors.
• Connection settings are returned to factory settings when defaults are restored. Perform settings
again after restoring defaults.
Bluetooth connections
Communication between a pair of Bluetooth devices requires one device to be set as the
"Master" and the other as the "Slave". DL is always the "Slave" device. Connections are initiated
from the paired device side
PROCEDURE Necessary settings for Bluetooth communication
1. Select "Config" in <Menu>.
2. Select "Comms setup" in <Config menu>.
3. Select "Bluetooth" in "Mode".
4. Set "Authenticate" to "Yes" or "No".
If "Authenticate" is set to "Yes" for the DL the
passkey will also need to be input on the
companion device.
9.1
Wireless Communication using Bluetooth Technology
Menu
1.Meas
2.Management
3.Config
4.Calculation
Config menu
1.Obs.condition
2.Instr.config
3.Comms setup
4.Tilt offset
5.Unit
INFO
Mode :Bluetooth
Authenticate:No
STX/ETX(CSV):No
DL-501_E.book 29 ページ ２０１５年９月１７日 木曜日 午後１時２１分
To Next Page
Loading...
Need help?
General
