Topcon DL-501 - 15.4 Restoring a JOB

15. SELECTING/DELETING A JOB
76
6. Align the cursor with "JOB id when restored"
and press [LIST]. The JOB list screen is
displayed.
Align the cursor with the desired destination
JOB id and press {}.
The screen shown at right is displayed.
Change JOB id as necessary.
Press [OK] to confirm settings.

• Data cannot be restored to a JOB id
already containing JOB data.
7. Press [OK] to start restore.
8. Press {} when "Output complete" is
displayed. The screen in step 4 is restored.
It is possible to delete backed up JOB data, and data created via SD mirroring from an external
memory device.
PROCEDURE
1. Select “Management” in <Menu>.
2. Select “JOB" in <Management menu>.
<JOB menu> is displayed.
3. Select “Backup JOB deletion”.
15.5 Deleting Backed Up Data
OK
JOB id
:Job-ahead02
Location :SD
JOB id in ext. memory
:Job-base02
JOB id when restored
:Job-ahead01
LIST OK
Location :SD
JOB id in ext. memory
:Job-base02
JOB id when restored
:Job-ahead02
LIST OK
Job menu
6.Backup JOB deletion
DL-501_E.book 76 ページ ２０１５年９月１７日 木曜日 午後１時２１分