Changing Receiver Modes
P/N 7010-0736
5-11
3. Any activity on the RS232 port will turn the receiver on.
Entering Zero Power Mode
When the receiver is off, even in Sleep Mode, the power board will
continue to draw power from the batteries. This means that if you
fully charge your receiver, turn it off and store it, the receiver will
drain its battery power in less than two months. To stop the various
boards and modules from draining the batteries, put your receiver in
Zero Power Mode.
1. Turn on your receiver.
2. Press and hold the power key for more than 8 seconds, but less
than 14 seconds.
3. Release the power key when both LEDs become red. When the
LEDs turn off, your receiver will be in Zero Power Mode.
4. Press the Reset key for about one second to return to Normal
mode.
NOTICE
If you press the power key for more than 14
seconds, it will be ignored. This protects receiver
operation against stuck keys.
NOTICE
When the internal batteries have completely
discharged and no external power is connected, the
receiver will go into Zero Power Mode to prevent
the batteries from over discharging.
To Next Page
Loading...
