Topcon HiPer+ - RX LED Blink Pattern on Error Conditions

Troubleshooting
HiPer+ Operator’s Manual
6-14
RX LED Blink Pattern on Error
Conditions
For internal UHF modems: the RX LED flashes.
D An initialization error has occurred.
• Check that the radio modem’s antenna is undamaged.
Contact your dealer to replace the antenna.
• Check that the radio modem’s antenna is securely and
properly connected to the antenna connector on the
radome.
For internal GSM modems: the RX LED flashes orange.
D The Rover uses the wrong PIN code, or no PIN code was
selected.
1. In TopSURV, click JobConfigSurvey.
2. Click the “...” (continue) button and press Next to
navigate to the Rover Radio configuration screen.
3. Press Configure GSM.
4. Select the PIN of the Base Station and press OK.
D An initialization error has occurred.
• Check that the radio modem’s antenna is undamaged.
Contact your dealer to replace the antenna.
• Check that the radio modem’s antenna is securely and
properly connected to the antenna connector on the
radome.