Loading New Firmware
P/N 7010-0736
5-13
2. Watch for the delimiter double-blink. With good receiver,
antenna, and observation conditions, all blinks should be green
within 15 minutes of powering on.
• Green – ok
• Orange – wait
• Red – some tests failed
3. To switch back to normal mode, press the FN key.
Loading New Firmware
Base and Rover receivers must be loaded with the same firmware
version. Use the latest firmware version, available for download from
the TPS website, to ensure your receiver has the most recent updates.
The receiver board and power board must be loaded with firmware
from the same package. The Bluetooth module’s firmware is
independent of the receiver card and power board, and has a different
firmware package (for receiver’s with a Bluetooth module).
The receiver uses FLoader, a Windows®-based utility, to load
firmware onto the receiver and power boards. You can download
FLoader to your computer from the TPS website. For more
information, refer to the FLoader User’s Manual, also available on
the TPS website. See “Installing FLoader” on page 2-6 for installing
FLoader on the computer.
1. Download the new firmware package to your computer.
2. Connect your receiver and computer. See “Connecting the
Receiver and a Computer” on page 2-14 for this procedure.
NOTICE
The HiPer+ receiver must be loaded with firmware
version 3.0 or newer.
CAUTION
Do not attempt to load firmware older than 3.0.
To Next Page
Loading...
