Topcon HiPer+ - Minter

Introduction
HiPer+ Operator’s Manual
1-8
MINTER
The MINTER is the receiver’s minimum interface used to display and
control data input and output (Figure 1-2). The slant height measure
mark (SHMM) is used when measuring the height offset of the
receiver.
Figure 1-2. Receiver MINTER
The Reset button causes a hard reset of the receiver and the receiver
to leave Zero Power Mode and return to Normal Mode.
The Power button turns the receiver on and off.
NOTICE
Only use this procedure if the receiver does not
respond to commands or does not charge the
internal batteries (is in Zero Power Mode).
Record LED
Slant Height Measure Mark
Modem Status LED
FN Button
Power Button
Status LED
Reset Button
Battery LED