Pre-survey Preparation
HiPer+ Operator’s Manual
2-6
Installing FLoader
FLoader is a firmware loading program for the power board, GPS
module, and modem board inside the receiver. FLoader is available
from the TPS website or on the GPS+ CD.
Computer requirements for FLoader are: Windows® 98 or newer and
an RS-232C port or Bluetooth wireless technology. Use FLoader
version 1.0.07 or newer to correctly configure the receiver.
1. Create an FLoader folder on your hard drive and place the
compressed FLoader zip file (retrieved from either the website or
the GPS+ CD) in this folder.
2. Navigate to the FLoader folder and double-click the FLoader zip
file.
3. Extract the FLoader.exe to the FLoader folder (Figure 2-4).
4. Create a shortcut on the computer’s desktop for quick access to
FLoader (Figure 2-4).
Figure 2-4. Extract Program and Create Shortcut
To uninstall FLoader, navigate to the location of the *.exe file. Select
the file and press Delete.
To Next Page
Loading...
