Topcon HiPer+ - Turning On;Off the Receiver; Connecting the Receiver and a Computer

Pre-survey Preparation
HiPer+ Operator’s Manual
2-14
Turning On/off the Receiver
To turn ON the receiver, press and hold the power button until the
LEDs briefly flash.
To turn OFF the receiver, press and hold the power key for more than
one and less than four seconds (until both the STAT and the REC
LEDs are off). This delay (about 1 second) will prevent the receiver
from being turned off by mistake.
Connecting the Receiver and a
Computer
Topcon’s PC-CDU software provides an interface for various
configuration, monitoring, and management functions for the
receiver.
To configure, manage files, or maintain the receiver, connect the
receiver and a computer using one of the following methods and start
PC-CDU:
• an RS232 cable and a computer/controller
• a USB cable and a computer/controller with the TPS USB driver
installed
• a receiver with a Bluetooth module and a Bluetooth-enabled
external device (computer/controller)
Once you have established a connection between the receiver and the
computer/controller, you will be able to configure the receiver and its
components, send commands to the receiver, download files from the
receiver’s memory; as well as, upload new firmware using
FLoader™, upload an OAF, and upload configuration files to a
receiver.