Troubleshooting
HiPer+ Operator’s Manual
6-8
D The transmitting and/or receiving antenna may be improperly
connected.
• Check that the radio modem’s antenna is securely and
properly connected to the antenna connector on the
receiver.
• Check that the radio modem’s antenna is undamaged. If
damaged, contact your TPS dealer to replace the antenna.
D The specified baud rate is incompatible with the baud rates the
modem supports.
The baud rate is the rate at which the receiver transmits
differential messages to the modem and vice versa.
Change the baud rate to that which your modem supports.
Refer to the modem’s manual for baud rate support
information.
D The Base and Rover modems use different radio link
parameters.
Configure the Base and Rover radio modems according to the
procedures listed in the applicable section.
• For details on a UHF modem, see “Configuring a UHF
Radio Modem” on page 3-4.
• For details on a GSM modem, see “Configuring a GSM
Radio Modem” on page 3-11.
D The specified link rate is not compatible with the link rates the
modem supports. The link rate is the rate at which data
transmits over the RF link.
• Change the link rate to that which your modem supports.
See the modem’s manual for link rate support information.
• See “Configuring the Radio Modem” on page 3-3 for
checking the current link rate and changing the link rate.
D The distance between the Base and Rover is too far.
• Close the distance between the Base and Rover.
• Use repeaters to increase radio coverage.
To Next Page
Loading...
