Topcon HiPer+ - Page 46

Pre-survey Preparation
HiPer+ Operator’s Manual
2-16
The receiver and external device connection procedure varies slightly
depending on the type of external device used. In general, the
connection procedure is as follows.
Refer to your Bluetooth-enabled external device documentation for
detailed connection information.
1. Turn on a Bluetooth-enabled external device and the receiver. The
default external device mode is Master; the receiver’s Bluetooth
module mode is Slave.
2. Instruct the external device (Master) to search for the receiver
(Slave).
3. Once the Master device detects the receiver, use the procedure
described in the external device’s documentation to connect it
with the receiver.
4. Connect to the desired configuration software (PC-CDU,
BTCONF, etc.) as described in the configuration sections.
If you cannot establish a connection, check that the receiver’s slot
three is enabled.
1. Connect your receiver and a computer using an RS232 cable or
USB cable and PC-CDU as seen below.
2. Click ConfigurationReceiverGeneral.
3. In the Turn on/off Slots area, ensure the Slot 3 (B) check box is
enabled.