Topcon TRK-2P - SELECTING THE MEASUREMENT MODE

30
BASIC OPERATIONS
BASIC OPERATIONS
OPERATION FLOW CHART
BASIC OPERATIONS
OPERATION FLOW CHART
MEASURING PROCEDURE IN REF/KRT→TONO/PACHO CONTINUOUS MEASUREMENT
TURNING ON THE INSTRUMENT (page 31)
SELECTING THE MEASUREMENT MODE
(page 32)
CHECKING THE MEASURING NOZZLE
(page 33)
AIR CHECK (page 34)
SETTING THE PATIENT ID (page 36)
PATIENT POSITIONING (page 37)
SETTING THE SAFETY STOPPER
(page 38)
SETTING THE AUTO MODE IN REF/KRT
(page 42)
SETTING THE AUTO MODE IN
TONO/PACHO (page 44)
PRINT-OUT OF MEASUREMENT VALUES
(page 49)
OPERATION AFTER USE (page 56)
MEASUREMENT IN
REF/KRT→TONO/PACHO
CONTINUOUS
MEASUREMENT
Insert the power cable plug
into the commercial power.
PREPARATION BEFORE
MEASUREMENT