Topcon TRK-2P - Operation after Use

56
BASIC OPERATIONS
BASIC OPERATIONS
OPERATION AFTER USE
OPERATION AFTER USE
1 Tap the button on control panel in R/K measurement mode, and tap the
button on control panel in T/P measurement mode.
2 Then, the confirming message of End operation is displayed in R/K measurement mode, and
the message of Air check/End operation is displayed in T/P measurement mode.
3 Tap the button. Return the chinrest and measuring head to their last positions.
4 The message of "Please don't turn the main switch off until the unit stops." is displayed.
5 The operation is complete, then the message of "The unit stops completely. Please turn the
main switch off." is displayed.
6 Turn the switch to off.
7 If external device is connected, turn off the device.
8 Unplug the power cable from a 3-pin AC inlet with grounding.
NOTE
When external devices are connected to external I/O terminals, turn off the
power of these devices too. (If the switch is provided.)
NOTE
When the instrument is not used for a long period of time, unplug the power
supply cable, and detach the cable connected to the external I/O terminal.
End
Air check/End
終了 キャンセル チェック 終了 キャンセル
Turn off the unit?
Perform air check
or Turn off the unit?
CANCELCANCEL Air Check Turn offTurn off
R/K measurement mode T/P measurement mode
Turn off
POWER
POWER