Topcon TRK-2P - Manual Mode in Ref;Krt; Manual Mode; Alignment and Measurement

59
OPTIONAL OPERATIONS
MANUAL MODE IN REF/KRT
MANUAL MODE
1 Check that the MEASUREMENT screen is on. If the button is "M," the mode is
Manual mode.
2 If "A" (Auto mode) is displayed, tap it and change to "M".
ALIGNMENT AND MEASUREMENT
Alignment is operated on the control panel.
1 Select the right/left eye by tapping the button/ button.
NOTE
• Adjust the height of the instrument table so that the patient can sit com-
fortably. Otherwise, correct measurement values may not be obtained.
• If the machine is moved before measurement values are displayed, it may
cause incorrect measurement results.
• The beep function for urging cautions is provided so that a finger or a
hand is not pinched between the reverse side of forehead rest, a measur-
ing head and an ocular pressure measurement window.
Auto/Manual
Focusand
Touchameasurepoint
PatientID




13.75
13.75





1
1
R
R
S
S
S
S
S
S
C
C
C
C
A
A
A
A
C
C
A
A
K
K
R1
R1
R2
R2
A
1
A1
R
R
S
S
C
C
A
A
K
K
R1
R1
R2
R2
A
1
A1
VD
VD
mm
mm
TO
PC
O
N

TAR
OU
TOPCONTAROU
MODE
MANUAL
R/K
R
L
Focusand
Touchameasurepoint
PatientID




13.75
13.75




-1.25
-1.25
-0.50
-0.50


1
1
R
R
S
S
S
S
S
S
C
C
C
C
A
A
A
A
C
C
A
A
K
K
R1
R1
R2
R2
A1
A1
R
R
S
S
C
C
A
A
K
K
R1
R1
R2
R2
A1
A1
VD
VD
mm
mm
T
OPC
ONT
AROU
TOPCONTAROU
MODE
AUTO
R/K