Topcon TRK-2P - Displaying Measurement Values; For Explanation of the Messages on the Control Panel Screen, Refer to; Message List

63
OPTIONAL OPERATIONS
6 Measurement is performed and measurement values are displayed on the control panel.
DISPLAYING MEASUREMENT VALUES
With regard to measurement values, data of the latest measurement is displayed on the control
panel.
Figures only: Measurement was done correctly.
ERROR: Measurement was not done correctly.
NOTE
• Even if the alignment is not correct, measurement can be performed by
tapping the button. To ensure correct measurement with high
accuracy, try to get correct alignment.
• If the machine is moved before measurement values are displayed, it may
cause incorrect measurement result.
• When rotating the control panel to operate it at the upper part of the prod-
uct, do not press the button too hard, so as not to lose the
alignment.
NOTE
For explanation of the messages on the control panel screen, refer to
"MESSAGE LIST" on page 99.
Start
Start
Focusand
Touchameasurepoint
PatientID
3
3
3
3
-1.25
-1.25
-0.50
-0.50
180
180
7.80
7.80
7.80
7.80
13.75
13.75
-1.25
-1.25
-0.50
-0.50
180
180
180
180
3
3
3
3
-1.25
-1.25
-1.25
-1.25
-0.50
-0.50
-0.50
-0.50
7.80
7.80
7.75
7.75
180
180
180
180
180
180

1
1
R
R
S
S
S
S
S
S
C
C
C
C
A
A
A
A
C
C
A
A
K
K
R1
R1
R2
R2
A1
A1
R
R
S
S
C
C
A
A
K
K
R1
R1
R2
R2
A1
A1
VD
VD
mm
mm
TOPCON

TARO
U
TOPCONTAROU
MODE
MANUAL
R/K