Decal 144-3952: Af x over Decal 139-6215 (as
shown in the CE Kit Installation Instructions) for use
in CE-compliant countries (Models 31900 and 31901
only).
decal144-3952
144-3952
Note: This machine complies with the industry standard
stability test in the static lateral and longitudinal tests with the
maximum recommended slope indicated on the decal. Review the
instructions for operating the machine on slopes in the Operator ’ s
Manual as well as the conditions in which you would operate the
machine to determine whether you can operate the machine in the
conditions on that day and at that site. Changes in the terrain can
result in a change in slope operation for the machine.
1. Read the Operator ’ s
Manual .
5. T ipping hazard—do not
mow across slopes greater
than 16 degrees; do not
mow up and down slopes
greater than 16 degrees.
2. T ipping hazard—do not
mow across slopes greater
than 13 degrees; do not
mow up and down slopes
greater than 13 degrees.
6. T ipping hazard—do not
mow across slopes greater
than 17 degrees; do not
mow up and down slopes
greater than 17 degrees.
3. T ipping hazard—do not
mow across slopes greater
than 14 degrees; do not
mow up and down slopes
greater than 14 degrees.
7. T ipping hazard—do not
mow across slopes greater
than 18 degrees; do not
mow up and down slopes
greater than 18 degrees.
4. T ipping hazard—do not
mow across slopes greater
than 15 degrees; do not
mow up and down slopes
greater than 15 degrees.
8. T ipping hazard—do not
mow across slopes greater
than 19 degrees; do not
mow up and down slopes
greater than 19 degrees.
10
To Next Page
