16
Installing the CE Kit
Parts needed for this procedure:
1
CE Kit (ordered separately; refer to your authorized
T oro distributor)
Procedure
If you operate the machine in a country that complies
to CE standards, install the CE Kit; refer to the kit
Installation Instructions .
17
Adding Rear W eight
Parts needed for this procedure:
W eight—19 kg (42 lb) [amount varies per your model]
W eight—6 kg (15 lb) [amount varies per your model]
1
W eight Bracket Kit (if necessary)
W eight—1 1 kg (25 lb) [amount varies per your model]
Refer to the following table for the weight that is shipped with each machine:
Model
Shipped Rear W eight
31900A
2 weights (19 kg or 42 lb each)
31901A
1 weight (19 kg or 42 lb)
31907A 0 weights
31909A
5 weights (19 kg or 42 lb each) and 2 weights (6 kg or 15 lb each)
Determining the Required Rear W eight
Ensure that your machine has the minimum amount of rear weight per your traction unit and attachment
combination. For Models 31900A, 31901A, and 31907A, you can also add more rear weight for improved
slope performance.
• T o determine the minimum number of weights required, refer to the Minimum Required Rear W eight
( page 22 ) table.
• T o achieve an improved slope performance, add the number of each weight type as listed in the Required
Rear W eight for Improved Slope Performance ( page 24 ) table.
T o ensure proper ROPS performance, do not add more weight than what is listed in this table.
Note: If you have an equipped CE Kit, refer to the kit Installation Instructions for the appropriate slope decal for
your traction unit and attachment combination. Ensure that the correct amount of rear weight is added (i.e.,
weight to meet required slope standard or weight to meet improved slope performance).
21
To Next Page
