Toro Groundsmaster 7210 - Fuel Pump

FuelPump
g034746
Figure167
1.Fuelsupplyhose
3.ROPStube
2.Leftfueltank
4.Fuelpump
ThefuelpumpisattachedtotheROPStubeneartheleftfueltank(Figure167).
TheStandardControlModuleRunoutputLEDilluminateswhenthefuelpump
isenergized.
TestingtheFuelPump
1.Parkthemachineonalevelsurface,lowerthecuttingdeck(orimplement),
shutofftheengine,andsettheparkingbrake.Ensurethatthekeyswitch
isintheOFFposition.
2.Unlatchtheoperatorseatandraiseittogetaccesstothefuelpump.
3.Removethe3swelllatchesthatattachtherearpaneltothecrossmember
ofthemachine,andremovetherearpanelandpositionitawayfromthe
machine.
4.Unlatchthehoodandraiseit.
5.Disconnectthefuelsupplyhose(pumpdischarge)fromtheinletttingon
thefuellter.
6.Ensurethatthefuelhosesattachedtothefuelpumparefreeofobstructions.
7.Placethedisconnectedfuelsupplyhose(pumpdischarge)intoalarge,
graduatedcylindersufcientenoughtocollect0.9L(32oz).
IMPORTANT
Whentestingthefuelpump,donotturnthekeyswitchtotheSTART
position.
8.TurnthekeyswitchtotheONpositionandcollectthefuelinthegraduated
cylinder.Allowthepumptorunfor30secondsandthenreturntheswitchto
theOFFposition.
Groundsmaster7210
Page5–43
ElectricalSystem:TestingtheElectricalComponents
16222SLRevC