Toro Groundsmaster 7210 - Page 296

RemovingtheRolloverProtectionSystem(continued)
g036980
Figure210
1.Venthose(2each)2.Oilbreather
3.Removethe2doubleloophairpincotters(item10inFigure209)fromthe2
foldpinsandpullthefoldpinsfromtheROPSsupportplate.
4.Removethe2screws(item7inFigure209)and2nutsfromtheROPS
supportplate,andremovetheROPStube.
5.Removethe3swelllatches(item2inFigure209)thatsecuretherearpanel
tothecross-memberassembly,andremovetherearpanel.
6.Disconnecttheventhose(item1inFigure210)fromthetopofeachfueltank.
7.Disconnecttheoilbreather(item2inFigure210)fromthehydraulichose.
8.Removethe4screws(item3inFigure209)and4angenutsthatsecurethe
cross-memberassemblytotheROPStubes,andremovethecross-member
assembly.
InstallingtheRolloverProtectionSystem
1.Installthecross-memberassembly(item14inFigure209)totheROPStube
withthe4screwsand4angenuts.
2.Connecttheventhose(item1inFigure210)atthetopofeachfueltank.
3.Installtheoilbreather(item2inFigure210)tothehydraulichose.
4.Installtherearpanel(item1inFigure209)tothecross-memberassembly
withthe3swelllatches.
5.InstalltheROPSsupportplateandROPStubewiththe2screws(item7
inFigure209)and2nuts.
6.Insertthe2foldpins(item6inFigure209)intotheROPSsupportplateand
insertthe2doubleloophairpincotters.
7.Lowertheoperatorseat.
Chassis:ServiceandRepairs
Page6–34
Groundsmaster7210
16222SLRevC