Toshiba B-SX5 Series - Option Check Details; Failed Item Numbers

- 120 -
NOTE: Option Check Details
By installing the tool for option check, the following connectors on the board are checked:
the solenoid connector (CN11), the peeled-off paper sensor connector (CN20), rewinder
overflow sensor connector (CN4), the rotary cutter detection connector (CN18).
If the check results in a failure, then the failed item number is displayed on the LCD.
[Failed item numbers]
1: Solenoid connector (CN11)
2: Peeled-off paper sensor connector (CN20)
3: Rewinder overflow sensor connector (CN4)
4: Rotary cutter detection connector (CN18)
* When the check is performed, all connectors of the tool for the option check must be
connected. A connector which is also used for supplying the power is included. If all
connectors are not connected, the check is not properly performed. Several failed
item numbers may be displayed.