Toshiba B-SX5 Series - Back Feed Speed Setting (BACK SPEED); November; Pre-Peel-Off Process Setting (PRE PEEL OFF); Print Head Type Setting (THERMAL HEAD)

- 72 -
(28) Pre-peel-off process setting (PRE PEEL OFF)
• OFF: Pre-peel-off operation is not performed..
• ON: Pre-peel-off operation is performed.
NOTE: When the printer speed “10 ips” is specified, the pre-peel-off
operation is performed, even if it is set to OFF in this setting.
(29) Back feed speed setting (BACK SPEED)
• STD: 3 ips
• LOW: 2 ips
(30) MaxiCode specification setting (MAXI CODE)
• TYPE1: Compatible with the current version
• TYPE2: Special specification
The mode specified by the command may be different from the actual mode, depending on
the status of this parameter. Also, the data transmission method differs partly.
For details, refer to the B-SX4/SX5 External Equipment Interface Specification.
(31) Print head type setting (THERMAL HEAD)
B-SX4 B-SX5
• V2: Enhanced type TPH104R7 TPH128R5 or equivalent
• V1: Current type TPH104R2 TPH128R4
B-SX4: V2 type print head (TPH104R7 or equivalent) in or after September 2004
B-SX5: V2 type print head (TPH128R5 or equivalent) in or after November 2004
NOTE 1: Selecting the incorrect print head type may affect the
print quality or print head life.
NOTE 2: The enhanced print head (B-SX4: TPH104R7 or
equivalent, B-SX5: TPH128R5 or equivalent) has a
red line on the side. (See the picture on the left.)
Supplementary explanation
• When the [RESTART] and [FEED] keys are pressed at the same time, the display shows
the system mode menu.
• If the [RESTART] or [FEED] key is held down for 0.5 seconds or more when a parameter
is being set, the printer enters the repeat mode, in which the key is entered repeatedly.
• A changed parameter is stored in memory by pressing the [PAUSE] key.
FEED
RESTART
FEED
RESTART
FEED
RESTART
FEED
RESTART
Red line