Toshiba B-SX5 Series - Test Print

- 87 -
6.5 TEST PRINT
6.5.1 Test Print Operation Example
(1) Normal test print
< 1 > D I A G . V 1 . 0 A
< 2 > P A R A M E T E R S E T
< 3 > A D J U S T S E T
< 4 > T E S T P R I N T
< 4 > T E S T P R I N T
P R I N T C O N D I T I O N
< 4 > T E S T P R I N T
I S S U E C O U N T 1
< 4 > T E S T P R I N T
P R I N T S P E E D 6 ” / s
< 4 > T E S T P R I N T
S E N S O R T R A N S .
(11) Test print condition setting mode
(13) Issue count setting mode:
Set the issue count using the [FEED]
and [RESTART] keys.
(9) System mode menu display
(
Test print
)
(4) Press the [FEED] key.
(5) System mode menu display
(Parameter setting)
(3) The self-test menu is displayed.
(2) While holding the [FEED] and [PAUSE]
keys down, turn the power on.
(1) Power off state
Power OFF
(14) Press the [PAUSE] key.
(17) Sensor selection mode:
Select the sensor using the [FEED] and
[RESTART] keys.
(10) Press the [PAUSE] key.
(12) Press the [PAUSE] key.
(15) Print speed setting mode:
Select the print speed using the [FEED]
and [RESTART] keys.
(16) Press the [PAUSE] key.
[FEED] [PAUSE]
[FEED]
[PAUSE]
[PAUSE]
[PAUSE]
[PAUSE]
(6) Press the [FEED] key.
[FEED]
(7) System mode menu display
(Fine adjustment value setting)
(8) Press the [FEED] key.
[FEED]
(18) Press the [PAUSE] key.
[PAUSE]