Toshiba B-SX5 Series - Print Conditions; Size of Receive Buffer; Basic Expansion Mode

- 24 -
Print conditions:
• Print width: Approximately 100 mm
• Sensor designation: None
• Print speed: 6 ips for B-SX4, 5 ips for B-SX5
• The print mode (thermal transfer/direct thermal) depends on the current setting.
• Data of 16 bytes is printed on one line.
• Data is printed, starting from the new data to the old data.
• Data pointed by the receive buffer write pointer is printed in bold type.
Size of receive buffer
B-SX4 B-SX5
RS-232C: 1 MB (Max. 65536 lines) 6 MB (Max. 393216 lines)
Centronics: 1 MB (Max. 65536 lines) 6 MB (Max. 393216 lines)
Network I/F: 1 MB (Max. 65536 lines) 6 MB (Max. 393216 lines)
BASIC1: 8 KB (Max. 512 lines) 8 KB (Max. 512 lines)
BASIC2: 8 KB (Max. 512 lines) 8 KB (Max. 512 lines)
USB: 1 MB (Max. 65536 lines) 6 MB (Max. 393216 lines)
RFID 8 KB (Max. 512 lines) 8 KB (Max. 512 lines)
NOTES:
1. To print all of the receive buffer data, the label with the length below is required.
B-SX4 B-SX5
RS-232C: 198.2 m 1189.2 m
Centronics: 198.2 m 1189.2 m
Network I/F: 198.2 m 1189.2 m
BASIC1: 2 m 2 m
BASIC2: 2 m 2 m
USB: 198.2 m 1189.2 m
RFID 2 m 2 m
2. If an error occurs when printing the receive buffer dump, the printer displays an error
message, and stops. The error is cleared by pressing the [PAUSE] key, and then the
display is returned to the receive buffer dumping menu “<4> DUMP MODE”. After the
error is cleared, data is not automatically reprinted.
5.10 BASIC EXPANSION MODE
It is possible to execute the BASIC expansion mode program in BASIC expansion mode under the
following conditions:
- The BASIC expansion mode program has already been loaded.
- The BASIC enable setting mode is selected.
The basic expansion mode ends when the basic expansion program is exited.