Toshiba B-SX5 Series - RAM Clear Contents; RAM Clear Mode; Selection of Destination Type; Initial Values after Maintenance Counter Clear

- 104 -
6.7.2 RAM Clear Contents
(1) RAM clear mode
• NO RAM CLEAR
• MAINTE.CNT CLEAR
• PARAMETER CLEAR
(2) Selection of destination type
• QP TYPE (for Europe/Asia)
• QQ TYPE (for North/South America/China)
• CN TYPE (for China)
• QM TYPE (for North/South America/ Europe/Asia/China)
(3) Supplementary explanation
• When the [FEED] and [RESTART] keys are pressed at the same time, the display shows
the system mode menu.
• When “COMPLETE” is displayed after RAM clear is complete, be sure to turn off the
power.
• The total label distance covered, sensor adjustment values (system mode <5>), the IP
address setting, languages for LCD messages, and data of flash memory card and ATA
card are not cleared by RAM clear.
• Number of successful RFID write and number of failure in RFID write cannot be cleared by
RAM clear.
• System password setting cannot be cleared by RAM clear.
• The destination for which RAM clear has been performed ([QQ], [QP], [CN] or [QM]) is
printed on the top right-hand corner of the maintenance counter printout.
(4) Initial values after maintenance counter clear
Item Initial Value
Label distance covered 0 km
Print distance 0 km
Cut count 0
Head up/down count 0
Ribbon motor drive time 0 hours
Head-up solenoid drive time 0 hours
RS-232C hardware error count 0
System error count 0
Momentary power interruption count 0
FEED
RESTART
FEED
RESTART