Toshiba B-SX5 Series - Strip Position Fine Adjustment

- 82 -
[Strip position fine adjustment]
Printing in strip issue mode is stopped at the position where the
distance from the middle point of the gap between labels to the
end of the strip shaft is 4 mm, since the gap between labels is
assumed to be 2 mm.
When the print stop position is not proper due to a greater gap,
the print stop position should be adjusted using the strip
position fine adjust function.
+0.0 mm
+3.0 mm
- 3.0 mm
2 mm
4 mm
3 mm