Toshiba B-SX5 Series - 5.11 AUTOMATIC CALIBRATION SETTING (SUPPORTED FROM V4.4)

- 22 -
< 4 > D U M P M O D E
P R I N T O N D E M A N D
< 4 > D U M P M O D E
P R I N T A L L
< 4 > D U M P M O D E
N O W P R I N T I N G . . .
< 4 > D U M P M O D E
Selection of receive buffer (BUFFER)
• RS-232C RS-232C receive buffer
• CENTRO. Centronics receive buffer
• NETWORK Network I/F receive buffer
• BASIC1 Buffer between the BASIC interpreter I/F and the Interpreter
• BASIC2 Buffer between the BASIC interpreter and the printer
• USB USB receive buffer
• RF-ID RFID receive buffer
Selection of print method (PRINT)
• ON DEMAND Prints 166 lines of data (approx. 50 cm), then stops.
• ALL Prints all of receive buffer data, then stops.
FEED
RESTART
FEED
RESTART
(19) Print method selection:
Select the print method using the
[FEED] and [RESTART] keys.
(21) Print method selection:
Select the print method using the
[FEED] and [RESTART] keys.
[RESTART] (20) Press the [RESTART] key.
(18) 166 lines of data are printed.
[PAUSE] (22) Press the [PAUSE] key.
(23) Start of printing the remaining receive
buffer data
(24) All of the remaining data is printed.
(25) After printing is completed, the display
is returned to the receive buffer
dumping menu.