Toshiba B-SX5 Series - 6.8 IP ADDRESS SETTING

- 105 -
(5) Initial values after parameter clear
Parameter Initial Value
Feed fine adjustment (PC) 0 mm
Cut position (or strip position) fine adjustment (PC) 0 mm
Back feed fine adjustment (PC) 0 mm
Print density fine adjustment:
Thermal transfer print mode (PC)
0
Print density fine adjustment:
Direct thermal print mode (PC)
0
Ribbon motor drive voltage fine adjustment
(Rewind) (PC)
0
Ribbon motor drive voltage fine adjustment
(Back tension) (PC)
0
Feed fine adjustment (Key) 0 mm
Cut position (or strip position) fine adjustment (Key) 0 mm
Back feed fine adjustment (Key) 0 mm
Print density fine adjustment:
Thermal transfer print mode (Key)
0
Print density fine adjustment:
Direct thermal print mode (Key)
0
Ribbon motor drive voltage fine adjustment
(Rewind) (Key)
0
Ribbon motor drive voltage fine adjustment
(Back tension) (Key)
0
X-coordinate fine adjustment (Key) 0 mm
Transmissive sensor manual threshold fine
adjustment value
1.4 V
Reflective sensor manual threshold fine adjustment
value
1.0 V
Character code selection PC-850
Font “0” selection “0” (without slash mark)
Communication speed 9600 bps
Data length 8 bits
Stop bit length 1 bit
QP type NONE
QQ type NONE
CN type NONE
Parity
QM type NONE
QP type
QM type
XON/XOFF + READY/BUSY (DTR)
protocol:
(XON output when the power is on,
XOFF output when the power is off)
QQ type READY/BUSY (DTR) protocol
Transmission control
CN type XON/XOFF + READY/BUSY (DTR)
protocol:
(XON output when the power is on,
XOFF output when the power is off)