- 56 -
(4) Sensor check contents
SDRAM 8MB
Capacity of SDRAM (8 MB for B-SX4, 16 MB for B-SX5)
Memory for the system and drawing
SENSOR1 00000000,00000000
CARD SLOT 1 ATA
SLOT 2 LAN
ATA: ATA card is installed.
LAN: LAN card is installed.
FSH: Flash memory card is installed.
NO: ATA card or flash memory card which is not
formatted, is installed, neither card is installed.
Slot
PCMCIA card
Thermal head open sensor
1: The head is closed.
(If the head is opened, it is not printed.)
Blank (Fixed to 0)
Blank (Fixed to 0)
Cutter home position sensor
0: Home position
1: Outside the home position
Rewinder overflow sensor
0: Normal
1: Overflow
Ribbon rewind motor sensor
0: Outside the slit
1: Inside the slit
Ribbon back tension motor sensor
0: Outside the slit
1: Inside the slit
Strip sensor (Peel-off sensor)
0: Label is not present.
1: Label is present.
Thermal head-up sensor
1: The head is lowered.
(If the head is lifted, it is not printed.)
To Next Page
Loading...
