Toshiba B-SX5 Series - Page 63

- 60 -
< 2 > P A R A M E T E R S E T
D A T A L E N G . 8 b i t s
< 2 > P A R A M E T E R S E T
S T O P B I T 1 b i t
< 2 > P A R A M E T E R S E T
P A R I T Y E V E N
< 2 > P A R A M E T E R S E T
X O N + R E A D Y A U T O
< 2 > P A R A M E T E R S E T
L C D E N G L I S H
< 2 > P A R A M E T E R S E T
F O R W A R D W A I T O F F
< 2 > P A R A M E T E R S E T
F W / B K A C T . M O D E 1
< 2 > P A R A M E T E R S E T
H U C U T / R W D . O F F
< 2 > P A R A M E T E R S E T
S O L E N O I D T Y P E 2
< 2 > P A R A M E T E R S E T
R B N S A V E O N ( T A G )
(21) Language selection for LCD messages:
Select the language for LCD messages
using the [FEED] and [RESTART] keys.
(24) Press the [PAUSE] key.
(15) Stop bit length selection:
Select the stop bit length using the
[FEED] and [RESTART] keys.
(31) Ribbon saving system setting:
Determine whether or not the ribbon
saving system is used with the [FEED]
and [RESTART] keys.
(32) Press the [PAUSE] key.
(21) Language selection for LCD messages:
Select the language for LCD messages
using the [FEED] and [RESTART] keys.
(22) Press the [PAUSE] key.
[PAUSE]
(27) Setting for head-up operation in cut issue
mode:
Make the head-up operation setting or the
rewinder use setting using the [FEED] and
[RESTART] keys.
(28) Press the [PAUSE] key.
[PAUSE]
(13) Data length selection:
Select the data length using the [FEED]
and [RESTART] keys.
(14) Press the [PAUSE] key.
[PAUSE]
(16) Press the [PAUSE] key.
[PAUSE]
(18) Press the [PAUSE] key.
[PAUSE]
(20) Press the [PAUSE] key. [PAUSE]
(19) Transmission control method selection:
Select the transmission control method using
the [FEED] and [RESTART] keys.
(17) Parity setting:
Select the parity using the [FEED] and
[RESTART] keys.
(15) Stop bit length setting:
Select the stop bit length using the
[
FEED
]
and
[
RESTART
]
ke
y
s.
(23) Setting for forward feed standby:
Make the forward feed standby setting using
the [FEED] and [RESTART] keys.
(24) Press the [PAUSE] key.
(25) Setting for forward feed standby action:
When the forward feed standby is set to ON,
select the action of the forward feed standby
using the [FEED] and [RESTART] keys.
(26) Press the [PAUSE] key.
[PAUSE]
[PAUSE]
(26) Press the [PAUSE] key.
(29) Installed solenoid type setting:
Set which type of solenoid is installed,
TYPE 1 or TYPE 2, with the [FEED]
and [RESTART] keys.
(30) Press the [PAUSE] key.
[PAUSE]
[PAUSE]