Toshiba B-SX5 Series - Page 65

- 62 -
< 2 > P A R A M E T E R S E T
E X . I / O T Y P E 1
< 2 > P A R A M E T E R S E T
C E N T R O . M O D E S P P
< 2 > P A R A M E T E R S E T
P L U G & P L A Y O F F
< 2 > P A R A M E T E R S E T
L B L / R B N E N D T Y P 1
< 2 > P A R A M E T E R S E T
P R E P E E L O F F O F F
< 2 > P A R A M E T E R S E T
B A C K S P E E D S T D
< 2 > P A R A M E T E R S E T
M A X I C O D E T Y P E 1
< 2 > P A R A M E T E R S E T
T H E R M A L H E A D V 2
< 2 > P A R A M E T E R S E T
P A S S W O R D O F F - - - -
[PAUSE]
(53) Expansion I/O operation mode setting:
Select the operation mode using the
[FEED] and [RESTART] keys.
(54) Press the [PAUSE] key.
[PAUSE]
(57) Plug-and-play operation setting:
Set the plug-and-play operation using
the [FEED] and [RESTART] keys.
(58) Press the [PAUSE] key.
(63) Back feed speed setting:
Select the back feed speed using the
[FEED] and [RESTART] keys.
(69) System mode password operation setting:
Select the system mode password operation
using the [FEED] and [RESTART] keys.
[PAUSE]
(64) Press the [PAUSE] key.
(59) Label end/ribbon end process setting:
Select the label end or ribbon end process
using the [FEED] and [RESTART] keys.
(60) Press the [PAUSE] key.
(61) Pre-peel-off process setting:
Select the pre-peel-off process using the
[FEED] and [RESTART] keys.
(62) Press the [PAUSE] key.
[PAUSE]
[PAUSE]
[PAUSE]
(55) Centronics operation mode setting:
Select the operation mode using the
[FEED] and [RESTART] keys.
(56) Press the [PAUSE] key.
[PAUSE]
(66) Press the [PAUSE] key.
(65) MaxiCode specification setting:
Select the MaxiCode specification using
the [FEED] and [RESTART] keys.
[PAUSE]
(68) Press the [PAUSE] key.
(67) Print head type setting:
Select the print head type that is actually
installed, using the [FEED] and [RESTART]
keys.
[PAUSE]
(70) Press the [PAUSE] key.