4 Replacement Procedures 4.15 Fingerprint sensor board
4-38 [CONFIDENTIAL] QOSMIO G30 Maintenance Manual (960-546)
Installing the Fingerprint sensor board
The following describes the procedure for installing fingerprint sensor board (See Figure 4-
22).
1. Connect the fingerprint sensor cable to the connector CN9540 on the fingerprint
sensor board.
2. Install the fingerprint sensor board to the cover assembly.
3. Install the fingerprint sensor holder in place and slide it in the opposite direction of
arrow in the figure 4-22 while pushing the latch.
To Next Page
Loading...
