4.36 Fluorescent Lamp   4  Replacement Procedures    
QOSMIO G30  Maintenance Manual (960-546)  [CONFIDENTIAL]  4-81 
4  
4.36 Fluorescent lamp 
This system uses LCD module from the following supplier. 
Type Part No.  Supplier  Section 
G33C0002V110 LG. Philips  4.36.1 
17.1 inch  
G33C00034110 SHARP 
4.36.2 
NOTE:  - When working with a LCD module, always use a flat, grounded table. 
    - Handle the backlight unit in the environment without dust, such as on the clean 
bench. Keep the worktable free from any screws or other material that may 
scratch the LCD surface. 
      - Use an anti-static or protective sheet. 
      - When replacing the FL unit, cover with a finger protector or similar to prevent 
dirtying or scratching the LCD panel. 
      - Take care when handling the lamp. Excessive force may break the lamp. 
      - Take care not to dirty or deform the lamp reflector. 
      - Ensure always that the power of the LCD module is turned off before 
connecting or disconnecting cables and connectors.