4 Replacement Procedures 4.26 CPU heat sink fan/CPU
4.26 CPU heat sink fan/CPU
Removing the CPU heat sink fan/CPU
The following describes the procedure for removing the CPU heat sink fan/CPU (See Figure
4-37 and 4-38).
1. Remove the following screws securing the CPU holder.
• M2.0×4B BIND screw ×3
NOTE: When removing the CPU holder, be sure to remove the screws in the reverse
order of the number marked on the holder.
2. Remove the CPU holder.
3. Disconnect the CPU fan cable from the connector CN8771 on the system board and
remove the CPU heat sink fan from the slot.
M2.0x4B BIND
CPU holder
M2.0x4B BIND
CPU heat sink fan
CPU fan cable
CN8771
Figure 4-37 Removing the CPU heat sink fan
4-60 [CONFIDENTIAL] QOSMIO G30 Maintenance Manual (960-546)
To Next Page
Loading...
