4.20 LED board 4 Replacement Procedures
QOSMIO G30 Maintenance Manual (960-546) [CONFIDENTIAL] 4-51
Installing the LED board
The following describes the procedure for installing the LED board (See Figure 4-30).
1. Connect the LED cable to the connector CN9510 on the LED board.
2. Install the LED board to the base assembly.
3. Connect the LED cable to the connector CN9500 on the system board.
4. Secure the LED board with the following screw.
• M2.5×6S Tapping screw ×1
To Next Page
Loading...
