4.36 Fluorescent Lamp 4 Replacement Procedures
7. Turn the LCD module face down. Bend the circuit board inside and secure it with two
screws (C).
CAUTION: When handling the circuit board, do not hold both edges.
Position the circuit board by the rectangle hole close to the screw hole and
the BL unit pin.
The torque tightening screws shall be
0.1 N m
Figure 4-74 Replacing 17.1 Inch Sharp fluorescent lamp (15)
QOSMIO G30 Maintenance Manual (960-546) [CONFIDENTIAL] 4-103
To Next Page
Loading...
