Introduction Connections Basic Setup Playback
Editing
VCR Functions Others
Function Setup
Recording
41
EN
Method 3: If you press [DUBBING HDD DVD] on
the front panel in stop mode without
selecting any title, the unit will start
dubbing the last title in the Original List or
the Playlist. It will start dubbing the title in
the Original List if the Original List was the
last selected list. It will start dubbing the
title in the Playlist if the Playlist was the
last selected list.
• If the title was in the resume stop mode, the
dubbing will start from the resume point to the
end.
• If the title was in the regular stop mode, the
dubbing will start from the beginning of the title
to the end.
• If there is not enough space left on the disc, the
prohibited icon will appear and the dubbing will
not be started.
2 The dubbing will stop automatically
when it reaches the end of the title. If
you want to stop the dubbing
manually, follow the instructions
below.
To stop the dubbing in preparation mode:
•Press [DVD], then press [STOP S].
To stop the dubbing in progress:
•Press [DVD], then press and hold [STOP S] for
2 seconds. Or press [STOP S] on the front
panel.
• This operation may take awhile to be completed.
Note
• You cannot switch the device mode except between
DVD and VCR during HDD to DVD dubbing.
• High Speed Dubbing is not available for the One
Touch Dubbing.
One Touch Dubbing from videotape to
DVD
With One Touch Dubbing feature, you can start
dubbing right away with just one touch.
• Recordable DVD must be in the unit. (See
pages 28 to 30.)
• There should be enough space on the recording
DVD.
• A videotape to be dubbed must be in the unit.
• Make sure to press the corresponding Device
Select Button before using the device of your
choice.
Limitations:
• You cannot dub to the finalised Video mode
DVDs.
• You cannot dub to the protected VR mode
DVDs.
• If a copy control signal is detected during
dubbing, the dubbing will be stopped.
• Copy-once programmes which are recorded
directly from the TV can be dubbed to the
HDD / DVD.
• Copy-once programmes which are copied from
the HDD / DVD to a videotape cannot be
dubbed further from the videotape to the HDD /
DVD.
• If the unit detects that the dubbing will not finish
by 3 minutes before the Timer Recording, the
dubbing cannot be started. Be noted that with
VCR to DVD dubbing, the unit recognise DVD’s
remaining time as the dubbing duration although
the actual dubbing will end when the videotape
ends.
• You cannot dub to the DVD if the number of the
titles or the chapters of the disc is at its limit.
• Dubbing cannot be executed during recording of
any device.
• Dubbing cannot be executed while the Setup
Menu is showing (except for the Title List).
1 Play the contents you want to dub.
When it comes to the point where
you want to start dubbing from,
press [STOP S] or [PAUSE p].
Dubbing HDD DVD
XP
Dubbing
Title
1 : 00 :56 (XP)
Dubbing HDD DVD
XP
C
Dubbing HDD DVD
XP
E439BBD_EN.book Page 41 Wednesday, May 31, 2006 4:01 PM
To Next Page
Loading...
