90
EN
One-touch Timer Recording
This feature allows you to set the recording length
simply by pressing [REC / OTR I] (VCR).
1 Turn on the unit and insert a
recordable tape.
Make sure that the TV input is set on the unit.
2 Press [VCR].
3 Select the recording speed using
[REC MODE].
(See page 89.)
4 Select the desired channel to record
using [PROG.
/ ] or
[the Number buttons].
5 Press [REC / OTR I] (VCR)
repeatedly until the desired
recording time (30 minutes to 8
hours) appears on the TV screen.
One-touch Timer Recording will start.
• When the unit reaches the specified time, it will be
turned off automatically.
• To change the recording length during One-touch
Timer Recording, press [REC / OTR I] (VCR)
repeatedly until the desired length appears.
• To cancel One-touch Timer Recording within the
specified time, press [STOP S].
Note
• The remaining recording time will appear on the
front panel display during a One-touch Timer
Recording. Press [DISPLAY] can also see the
remaining recording time on the TV screen.
• You cannot pause a One-touch Timer Recording.
• If a basic recording or One-touch Timer Recording is
in progress on the VCR and the Timer Recording set
for HDD or DVD is about to begin, the unit will
automatically switch to the programmed channel
within 15 seconds before the programmed time and
the recording in progress on the VCR will be
cancelled UNLESS their recording channel is the
same. If their recording channel is the same, the
Timer Recording for HDD or DVD will start without
cancelling the recording currently in progress on the
VCR. In this case, the recording of the same
channel will be made on both VCR and the HDD or
DVD.
Search
Index search
An index mark will be assigned at the beginning of
each recording you make. You may skip to a specific
marked point by following the steps below.
1 Press [VCR].
2 Press [SEARCH MODE] to display
the index search menu.
3 Enter the number of recordings you
want to skip using
[the Number buttons] within 30
seconds.
4 Press [FWD f] or [REV r] to start
index search.
If you want to go in the forward direction, press
[FWD f].
If you want to go in the reverse direction, press
[REV r].
After index search, the VCR will play back the
tape automatically.
Note
• This function is not available during recording.
• Every time a tape is recorded, an index mark is
written on the tape.
Time search
This feature allows you to go to a specific point on a
tape by entering the exact amount of time you want to
skip in order to reach the point.
1 Press [VCR].
2 Press [SEARCH MODE] repeatedly
until the time search menu appears.
3 Enter your desired time to skip using
[the Number buttons] within 30
seconds.
4 Press [FWD f] or [REV r] to start
time search.
If you want to go in the forward direction, press
[FWD f].
If you want to go in the reverse direction, press
[REV r].
After time search, the unit will play back the tape
automatically.
Note
• This function is not available during recording.
•Press [STOP S] to stop the search.
• If the tape reaches the end during the Search, this
unit will cancel it and rewind the tape.
VCRVCR
0:30
8:00 7:30
1:00
(Normal Recording)
VCRVCR
VCRVCR
E439BBD_EN.book Page 90 Wednesday, May 31, 2006 4:01 PM
To Next Page
Loading...
