Voice Mail
Configuration
Voice Mail Configuration
Parameters
Strata CIX Voice Mail Programming 01/07 3-31
Table 3-12 Parameter Definitions
Parameter Description
sys_accept_0_calling_id Accept or reject 0 as calling ID in integration packet.
Possible values:
True: Accept 0.
False: (default) Reject 0.
sys_active_hold Controls how a caller must select to hold for a busy extension.
Possible values:
True: (default) Caller must continue pressing
*
to hold for a busy
extension, enter another extension, or leave a message at the tone.
False: Caller selects
*
once to hold for a busy extension and the system
allows the caller to hold until the is either transferred, selects
another extension, or presses
*
again to leave a message.
sys_amis_area_code Area code of the resident Stratagy ES MAS. Single quotes are required.
Default: blank comment line
sys_amis_country_code Country code of the resident Stratagy ES MAS. Single quotes are required.
Default: comment line starting with 1 for North America.
sys_amis_disk_full Percentage of the hard drive that must be free in order for Stratagy ES MAS
to accept new AMIS messages. If free space is less than this figure, The
Stratagy ES MAS tells the calling AMIS system that the hard drive is full.
Default: 5 (percent)
sys_amis_enabled Whether Stratagy ES processes incoming AMIS calls.
Possible values:
True: Voice mail processes incoming AMIS calls.
False: (default) AMIS calls told that this node is not accepting network
calls.
sys_amis_failure_retry Number of retries after failure.
Possible values: 0~9 (default = 3)
sys_amis_loopback_enable Enables the AMIS loopback test feature.
Possible values:
True: (default) enables feature
False: disables feature
sys_amis_ltm User Agent number to use for the AMIS Loopback mailbox. User Agent other
AMIS nodes can use for testing the network. Any AMIS message to this User
Agent is sent back to the sender, if accessible from this voice mail system.
Possible values: valid User Agent number.
Default: 989
sys_amis_max_msg Maximum number of messages the AMIS system can receive.
Default: 1000
sys_amis_max_node Maximum number of remote nodes (Gateway and Proxy User Agents) that
can be in the network. If the actual number exceeds this value, some nodes
are inaccessible.
Possible values: 1~256 (default = 255)
To Next Page
Loading...
