Advanced Integrations and Applications
VPIM Networking
10-16 Strata CIX Voice Mail Programming 01/07
VPIM Operation
Note VPIM messages can only be sent from mailboxes.
VPIM networking operation consists of the following steps:
Send VPIM Message Using Proxy Mailbox
1. The user logs into his/her mailbox.
2. From the Main Menu, the user presses
2 for the Send Messages menu.
3. The user enters the Proxy User Agent number as the destination address.
4. The user records the message and presses
# to stop recording.
5. The user presses
# again to send the message to the specified UA. The message is sent out as an
e-mail through the Internet and saved in the mailbox designated in the Destination Mailbox
field of the VPIM Proxy User Agent.
Send VPIM Message Using Gateway Mailbox
1. The user logs into his/her mailbox.
2. From the Main Menu, the user presses
2 for the Send Messages menu.
3. The user enters the Gateway User Agent number + the mailbox number at the remote server as
the destination address.
4. The user records the message and presses
# to stop recording.
5. The user presses
# again to send the message to the specified UA. The message is sent out as an
e-mail through the Internet and saved in the designated mailbox at the remote server.
To Next Page
Loading...
Need help?
General