Toshiba STRATA CIX - Page 191

Advanced Integrations and Applications
VPIM Networking
Strata CIX Voice Mail Programming 01/07 10-15
Advanced Integrations
and Applications
Step 1: Set VPIM Parameter
For VPIM to operate correctly, you must enable the VPIM configuration parameter setting,
sys_vpim_enabled, in the voice mail system. See “Modify Parameters” on page 3-30 for
instructions on modifying the setting for the VPIM parameter.
Important! If both the “local” and “remote” systems are Stratagy ES, you must have the
sys_vpim_enabled parameter set to 1 for enable.
Step 2: Create/Modify VPIM Gateway and/or Proxy User Agents
1. From the eManager screen, click Advanced Configuration > Voice Mail > VPIM Gateway or
VPIM Proxy. The appropriate screen displays.
2. Click Create. The Create User Agent screen displays.
3. From the Create screen, enter a single User Agent number (e.g., 881), a range of numbers (e.g.,
800-804) or a combination of both separated by commas (e.g., 800-802, 881, 888).
Note The number you enter must be unique. If the number already exists, Voice Mail
Administration indicates that the User Agent could not be created.
4. Click OK. The Creating dialog box displays while the program creates the User Agents. When
the process is complete, the screen indicates whether the creation of the User Agent(s) was
successful.
5. Click Exit. The VPIM Gateway or VPIM Proxy screen displays (see Figure 10-28 on page
10-13).
6. Highlight the User Agent number in the list to the right of the screen. The user agent is
displayed on the active screen.
7. (Optional) Click Comment field and type in a comment.
Note Comment should consist of GATEWAY or PROXY USER AGENT and any other
identifying information.
8. Check “Enabled” box on the screen.
9. In the Destination’s fully qualified domain name field, type the destination.
10. (For VPIM Proxy User Agent only) In the Destination Mailbox field, type in a different User
Agent.
11. Using the spin button, set the Notify After(min), Continue Every(min) and Notify Max Time
fields.
12. Click Update. The data is saved. The Edit VPIM User Agent screen closes.
13. Repeat Substeps 6~12 above for any other agents you created.