Toshiba TOSVERT VF-nC3E - 0-10 Vdc Voltage Input Adjustment; 4-20 Madc Current Input Adjustment; 0-5 VDC Voltage Input, or Used to Adjust External Volume

E6582233
F-13
6
1) 0-10Vdc voltage input adjustment
V
I terminal
 Po in t set t in gs a dj ust t he
frequency command for the
vo lt a ge inp u t.
 Gradient and bias can be set
easily.

100 (%)
10V voltage signal

0 ( Hz)

0 (%)
0

50 ( Hz )
Frequency commnd



(Voltage input: 0-10V)
2) 4-20mAdc current input adjustment
V
I terminal
 Poi nt settings adju st the frequency
co mmand for the current input .
 Ramp and bi as can be easily s et.
 With a current i nput of 0 to 20 mA,
se t   to .

100 (%)
20 mA cu rren t si gn al

0 ( Hz)

20 (%)
4

50 (Hz)
Frequency commnd
 
(Cu rre nt i npu t : 4 -20 mA )
3) 0-5 Vdc voltage input, or used to adjust external volume (P5-VI-CC)
VI t ermin al
* W hen t he external pote nti omet er is used, it is so t hat t he frequ ency set in  output. In case of the
voltage signal 0-5Vdc, whe n ou tput f requ ency does not mat ch t he val ue set in , please adju st
 or  (Refer to secti on 6.6. 4 for details).
 Point set tings adj ust the
frequency command for
the voltage input.
 Ram p and bias can be
eas ily set.

100(%)
?5 V vo lt ag e si gna l

0( Hz
)

0(%)
0 V
f204
50 (H z
)

(Voltage input: 0-5V)