E6582233
D-11
4
Default setting 1 ( = )
Setting to will return parameters to the standard values that were programmed at the factory.
☆ When is set, is displayed for a short time after the settings are configured, and then
disappears. Then the inverter is in standard motor mode. In this case, the trip history data is cleared.
Trip record clear ( = )
Setting to initializes the past four sets of recorded error history data.
☆ The parameter does not change.
Cumulative operation time clear ( = )
Setting to resets the cumulative operation time to the initial value (zero).
Initialization of type information ( = )
Setting typ to clears the trips when an format error occurs. But if the displayed, call us.
Save user setting parameters ( = )
Setting to saves the current settings of all parameters.
Load user setting parameters ( = )
Setting to loads parameter settings to (calls up) those saved by setting to .
☆ By setting to or , you can use parameters as your own default parameters.
Cumulative fan operation time record clear ( = )
Setting to resets the cumulative operation time to the initial value (zero).
Set this parameter when replacing the cooling fan, and so on
Number of starting clear ( = )
Setting to12 resets the number of starting to the initial value (zero).
Be aware that the following parameters do not return to the standard factory settings even if = is set
for maintainability.
: Meter selection : Analog output signal selection
: Meter adjustment gain :
Inclination characteristic of analog output
: Analog/logic input selection (VI terminal) : Analog output bias
: Sink/source switching : Factory specific coefficient 6D
: VI input bias : Free notes
: VI nput gain
: Logic output/pulse train output selection (OUT-NO)
To Next Page
Loading...
