Toshiba TOSVERT VF-nC3E - Setting Acceleration;Deceleration Time; Automatic Acceleration;Deceleration

E6582233
E-5
5
5.3 Setting acceleration/deceleration time
 ：Automatic acceleration/deceleration
 ：Acceleration time 1
 ：Deceleration time 1
 Function
1) For acceleration time 1  programs the time that it takes for the inverter output frequency to go
from 0Hz to maximum frequency .
2) For deceleration time 1  programs the time that it takes for the inverter output frequency to go
from maximum frequency  to 0Hz.
5.3.1 Automatic acceleration/deceleration
This automatically adjusts acceleration and deceleration time in line with load size.
 =
* Adjusts the acceleration/deceleration time automatically within the range of 1/8 to 8 times as long as the
time set with the  or , depending on the current rating of the inverter.
 =
* Automatically adjusts speed during acceleration only. During deceleration, speed is not adjusted
automatically but reduced at the rate set with .
Output
frequency (Hz)
Deceleration
time
Acceleration
time

When load is small
Time
[sec]
0
Shorten acceleration/deceleration time
Deceleration
time
Acceleration
time

When load is large
Output
frequency (Hz)
Time
[sec]
0
Lengthen acceleration/deceleration time
Set  (automatic acceleration/deceleration) to  or .
[Parameter setting]
Title Function Ad
j
ustment ran
g
e Default settin
g

Automatic acceleration/deceleration
0: Disabled (manual setting)
1: Automatic
2: Automatic
(
onl
y
at acceleration
)
0
☆ When automatically setting acceleration/deceleration time, always change the acceleration/deceleration
time so that it conforms to the load. The acceleration/deceleration time changes constantly with load
fluctuations. For inverters that require a fixed acceleration/deceleration time, use the manual settings
(, ).