Toshiba TOSVERT VF-nC3E User Manual

E6582233
F-26
6
6.13.2 Regenerative power ride-through control (Deceleration
stop)
 : Regenerative power ride-through control (Deceleration stop)
 Function
1) Regenerative power ride-through control:
When momentary power failure occurs during operation, this function makes operation continue
using the regeneration energy from a motor.
2) Deceleration stop during power failure:
When momentary power failure occurs during operation, this function stops the motor quickly and
compulsorily using the regeneration energy from the motor.
 Deceleration time varies according to load.
 When deceleration stop during power failure is operated, the message “” displays on the
operation panel.
 After the forced stop, the inverter remains static until you put off the operation command
momentarily.
[Parameter setting]
Title Function Adjustment range Default setting
f302
Regenerative power ride-through
control (Deceleration stop)
0: Disabled
1: Regenerative power ride-through control
2: Deceleration stop durin
g
power failure
0
Note 1: Even if these functions are used, a motor may coast according to load conditions.
In this case, use the auto-restart function (
f301) for the smooth restart after power supply is restored .
 An example of setting when f302=1
[When power is interrupted]
Note 2: If power is interrupted during deceleration stop, power ride-through control will not be performed.
●The time for which the operation of the motor
can be continued depends on the machine
inertia and load conditions. Before using this
function, therefore, perform verification tests.
●Use with the retry function allows the motor to
be restarted automatically without being
brought to an abnormal stop.
Motor speed
About 100ms~10s
Input voltage
Coasting stop
DC Voltage
Regenerative power
ride-through control selection

Toshiba TOSVERT VF-nC3E Specifications

General

Brand	Toshiba
Model	TOSVERT VF-nC3E
Category	Inverter
Language	English