E6582233
D-4
4
Standard setting mode : The mode changes to the Standard setting mode when
the EASY key is pressed and "" is displayed.
Both basic and extended all parameters are displayed.
Basic parameters : This parameter is a basic parameter for the
operation of the inverter.
Refer to chapter 5 for details.
Refer to chapter 10.2 for parameter tables.
Extended parameters : The parameters for detailed and special
setting.
Refer to chapter 6 for details.
Refer to chapter 10.3 for parameter tables.
For reasons of safety, the following parameters have been set up so that they cannot be reprogrammed while the
inverter is running.
［Basic parameters］
(Guidance function) *(Frequency setting mode selection)
(Automatic acceleration/deceleration) (Maximum frequency)
(Torque boost setting macro function) (V/F control mode selection)
*(Command mode selection) (Default setting)
［Extended parameters］
to
to to
, ,
to to
, , ,
, , , to
,
* and can be changed during operation by setting =.
To Next Page
Loading...
Need help?
General